Infiduino Uno R3 Starter-Intermediate Kit

Koristeno mozda dvaputa,
kit sam platio 60$ na ebayu, jos dodajem neke stvari tipa punjac i baterija u kit koje sam sam nabavio(kutije, multimetar, punjac, baterija...)

Partslist

• 1 x Infiduino Uno R3 Mainboard + 1 x USB cable (0.5m length)
• 1 x Infiduino Extension baord + 1 x GPIO Extension Board + 1 x Connecting Cable
• 1 x Big Breadboard (830 points)
• 1 x Mini Breadboard
• 10 x 3mm Red LEDs
• 10 x 3mm Green LEDs
• 10 x 3mm Yellow LEDs
• 1 x 5mm RGB LED
• 5 x Button with Cap
• 20 x 330 ohm resistor color ring
• 20 x 1k ohm color ring resistor
• 20 x 10k ohm color ring resistor
• 1 x 1K Adjustable Trim pot resistor (potentiometer)
• 1 x 10K Adjustable Trim pot resistor (potentiometer)
• 1 x 2.54mm Elbow 40 Pin Header
• 1 x 2.54mm Straight 40 Pin Header
• 1 x 5516 Light Dependent ResistorPhotoresistor
• 1 x Ball switch
• 1 x Active Buzzer 5V
• 1 x Passive Buzzer 5V
• 1 x MAX7219 Chip (Note the chip has been added since 2014-09-17)
• 1 x 8bit 74HC595 Shift Register
• 1 x LM35 Temperature Sensor
• 1 x SS8050 NPN transistor
• 1 x Infrared Receiver (model 1838)
• 1 x Infrared Sender
• 1 x Infrared Phototransistor (Flame Sensor)
• 1 x Infrared Remote Controller (Battery Not Included)
• 1 x Stepper Motor (5V)
• 1 x SG90 Servo motor
• 1 x 1602 LCD
• 1 x 1-Digit Eight-Segment Display
• 1 x 4-Digit Eight-Segment Display
• 1 x 8 * 8 Dot Matrix Led Display
• 1 x Stepper Motor Driver Board
• 1 x Sound Sensor Module (With "Digital" and "Analog" output)
• 1 x PS2 Joystick Module
• 1 x RTC module (Battery Not Included)
• 1 x Relay Module (5V-10A)
• 65 x Jump Wires
• 10 x Female-Female Dupont wires
• 10 x Male-Female Dupont wires
• 1 x 9V Battery Holder


+ Multimeter
+ 9V charger for Arduino
+ 9V battery
+ 3 x box for components Unused.